Corner, Stephen

Abstract Objective. Proton minibeam radiation therapy (pMBRT) is a novel spatially fractionated radiation therapy technique that offers improved tumor control and reduced normal tissue toxicity. However, its clinical translation has been hindered in part by limited field sizes, low dose rates, and complex manufacturing. This work describes the design, manufacturing, and commissioning of a novel divergent pMBRT collimator along with accessory components to maximize its versatility and facilitate clinical implementation. Approach. The dosimetric outcomes for pMBRT collimator geometry, including slit width, center-to-center (CTC) spacing, thickness, divergence, and field size, were evaluated using TOPAS Monte Carlo (MC) to maximize surface peak-to-valley dose ratio (PVDR) while maintaining uniform target coverage. The collimator was constructed using brass plates held by aluminum side holders. Commissioning measurements with a PTW Bragg peak chamber and EBT4 radiochromic film were compared to TOPAS and an in-house fast GPU-based MC simulation. Ancillary equipment consisting of lead foils, range shifters, custom apertures, and secondary pMBRT collimators were characterized in tandem. Main results. An optimized divergent pMBRT collimator with 0.5 mm slit width, 2.0 mm CTC distance, and 40 mm thickness produced a surface PVDR of 4.8 while preserving quasi-homogeneous dose in the 6–14 cm depth region. Measured dose profiles demonstrated valley dose agreement within 3% for both TOPAS and GPU-based MC predictions after the simulated collimator geometry was refined to match Bragg-peak chamber average dose measurements. The onset of the quasi-homogeneous dose region was shifted toward shallower depths by using thin lead foils, without significantly impacting entrance PVDR. Apertures sharpened penumbra and enhanced peripheral PVDR. A dual collimator approach produced 2D pinhole dose arrays that resulted in valley doses from MC simulations and film measurements agreeing within ∼5%. Significance. We demonstrated a practical low-cost, large-area divergent physical pMBRT collimation system with validated MC modeling. In addition, we introduce complementary accessories that substantially expand system versatility to facilitate clinical implementation.

AbstractBackground and purposeProton therapy is a key modality used in the treatment of ocular melanoma. Traditionally ocular sites are treated using a dedicated eyeline with a passively scattered proton beam and a brass aperture. This work aims to design and characterize a beam‐collimating aperture to treat ocular targets with a gantry‐based spot scanning proton beam.MethodsA plastic aperture system that slides into the gantry nozzle of a spot scanning proton beam was designed and constructed. It consists of an intermediate scraper layer to attenuate stray protons and a 3D‐printed patient‐specific aperture positioned 5.7 cm from the surface of the eye. The aperture system was modeled in TOPAS and Monte Carlo simulations were validated with film measurements. Two different spot configurations were investigated for treatment planning and characterized based on lateral penumbra, central axis (CAX) dose and relative efficiency. Alignment and leakage were investigated through experimental film measurements. Range was verified using a multi‐layer ionization chamber. Reference dose measurements were made with a PinPoint 3D ion chamber. Neutron dose was evaluated through Monte Carlo simulations.ResultsAperture alignment with radiation isocenter was determined to be within 0.31 mm at a gantry angle of 0°. A single‐spot configuration with a 10 mm diameter aperture yielded film‐measured lateral penumbras of 1 mm to 1.25 mm, depending on depth in the spread‐out Bragg peak. TOPAS simulations found that a single spot configuration results in a flat dose distribution for a 10 mm diameter aperture and provides a CAX dose of less than 106% for apertures less than 14 mm in diameter. For larger targets, adding four corner spots to fill in the dose distribution is beneficial. Trade‐offs between lateral penumbra, CAX dose and relative efficiency were characterized for different spot configurations and can be used for future clinical decision‐making. The aperture was experimentally determined to not affect proton beam range, and no concerning leakage radiation or neutron dose was identified. Reference dose measurements with a PinPoint ion chamber were within 2.1% of Monte Carlo calculated doses.ConclusionThe aperture system developed in this work provides a method of treating ocular sites on a gantry‐based spot scanning proton system. Additional work to develop compatible gaze tracking and gating infrastructure is ongoing.

AbstractObjectivesDefecation requires relaxation of the internal and external anal sphincters. High anal resting pressure is associated with painful constipation, defecatory disorders, and increased healthcare utilization in constipated patients; the mechanisms are unclear. Perhaps patients with a high anal resting pressure have a less distensible canal, which impedes defecation.MethodsIn 50 of 64 participants (33 healthy and 17 constipated women), anal pressures and distensibility were measured, respectively, with manometry and balloon distention combined with magnetic resonance imaging; rectal balloon expulsion time (BET) was also studied.ResultsThe BET (P = .006) was longer, and the mean (SD) rectoanal pressure gradient (−58[40] vs −34[26] mm Hg,P = .03) was more negative in constipated than healthy women; anal resting pressure was not different. During anal distention, the balloon expanded rapidly at an opening pressure of 49 (18) mm Hg, which was lower (P < .0001) than resting pressure (90 [25] mm Hg). The resting pressure was correlated with the opening pressure (r = 0.57,P < .0001) and inversely (r = −0.38,P = .007) with maximum volume but not with anal distensibility (volume‐pressure slope). In healthy women, the difference (opening‐resting pressure) was correlated with anal relaxation during evacuation (r = 0.35,P = .04). Anal distensibility and sensory thresholds were not different between constipated and healthy women.ConclusionsAmong healthy and constipated women, a greater anal resting pressure is correlated with greater opening pressure and lower maximum volume during distention, and, hence, provides a surrogate marker of anal distensibility. The difference (opening‐resting pressure), which reflects anal relaxation during distention, is correlated with anal relaxation during evacuation. Anal resting pressure and distensibility were comparable in healthy and constipated women.

A 24 mm COMS‐like eye plaque was developed to meet the treatment needs of our eye plaque brachytherapy practice. As part of commissioning, it was necessary to determine the new plaque's seed coordinates. The FARO Edge, a commercially available measurement arm, was chosen for this purpose. In order to validate the FARO Edge method, it was first used to measure the seed marker coordinates in the silastic molds for the standard 10, 18, and 20 mm COMS plaques, and the results were compared with the standard published Task Group 129 coordinates by a nonlinear least squares match in MATLAB version R2013a. All measured coordinates were within 0.60 mm, and root mean square deviation was 0.12, 0.23, and 0.35 mm for the 10, 18, and 20 mm molds, respectively. The FARO Edge was then used to measure the seed marker locations in the new 24 mm silastic mold. Those values were compared to the manufacturing specification coordinates and were found to demonstrate good agreement, with a maximum deviation of 0.56 mm and a root mean square deviation of 0.37 mm. The FARO Edge is deemed to be a reliable method for determining seed coordinates for COMS silastics, and the seed coordinates for the new 24 mm plaque are presented.PACS number: 87.53.Jw