Liu, Siying

AbstractFunctionally gradient materials emulate nature's ability to seamlessly blend properties through variations in material composition, unlocking advanced engineering applications such as biomedical devices and high‐performance composites. Additive manufacturing, particularly stereolithography, enables sophisticated 3D geometries with diverse materials. However, current stereolithography‐based multi‐material 3D printing is constrained by time‐intensive material switching and compromised interfacial properties. To overcome these challenges, we present dynamic fluid‐assisted micro continuous liquid interface production (DF‐µCLIP), a high‐speed multi‐material 3D printing platform that integrates varying compositions in a fully continuous fashion. By utilizing the polymerization‐free “dead zone”, vliquid resins are seamlessly replenished within a resin bath equipped with dynamic fluidic channels and a synchronized material supply system. DF‐µCLIP achieves ultra‐fast printing speeds of 90 mm/hour with 7.4 µ m pixel‐1 resolution while enabling on‐the‐fly material transitions. This strategy enhances mechanical strength at multi‐material interface through entangled polymer networks and promotes seamless material transitions between distinct materials ilike fragile hydrogels and rigid polymers, addressing interfacial failure caused by mismatch of swelling behavior. Additionally, dynamic material replenishment with real‐time composition control enables continuous gradient printing instead of the conventional step‐wise controlled gradient. Demonstrations include polymers with gradient color transitions and gradient carbon nanotube (CNT) composites with seamlessly varying conductivity.

As a treatment for the widely spread cardiovascular diseases (CVD), bypass vascular grafts have room for improvement in terms of mechanical property match with native arteries. A 3D‐printed nozzle is presented, featuring unique internal structures, to extrude artificial vascular grafts with a flower‐mimicking geometry. The multilayer‐structured graft wall allows the inner and outer layers to interfere sequentially during lateral expansion, replicating the nonlinear elasticity of native vessels. Both experiment and simulation results verify the necessity and benefit of the flower‐mimicking structure in obtaining the self‐toughening behavior. The gelation study of natural polymers and the utilization of sacrificial phase enables the smooth extrusion of the multiphase conduit, where computer‐assisted image analysis is employed to quantify manufacturing fidelity. The cell viability tests demonstrate the cytocompatibility of the gelatin methacryloyl (GelMA)/sodium alginate grafts, suggesting potential for further clinical research with further developments. This study presents a feasible approach for fabricating bypass vascular grafts and inspires future treatments for CVD.