Shukla, Dave R.

Background: Continuous passive motion (CPM) has been used for decades, but we are not aware of any randomized controlled trials (RCTs) in which CPM has been compared with physical therapy (PT) for rehabilitation following release of elbow contracture. Methods: In this single-blinded, single-center RCT, we randomly assigned patients undergoing arthroscopic release of elbow contracture to a rehabilitation protocol involving either CPM or PT. The primary outcomes were the rate of recovery and the arc of elbow motion (range of motion) at 1 year. The rate of recovery was evaluated by measuring range of motion at 6 weeks and 3 months. The secondary outcomes included other range-of-motion-related outcomes, patient-reported outcome measures (PROMs), flexion strength and endurance, grip strength, and forearm circumference at multiple time points. Results: A total of 24 patients were assigned to receive CPM, and 27 were assigned to receive PT. At 1 year, CPM was superior to PT with regard to the range of motion, with an estimated treatment difference of 9° (95% confidence interval [CI], 3° to 16°; p = 0.007). Similarly, the use of CPM led to a greater range of motion at 6 weeks and 3 months than PT. The percentage of lost motion recovered at 1 year was higher in the CPM group (51%) than in the PT group (36%) (p = 0.01). The probability of restoring a functional range of motion at 1 year was 62% higher in the CPM group than in the PT group (risk ratio for functional range of motion, 1.62; 95% CI, 1.01 to 2.61; p = 0.04). PROM scores were similar in the 2 groups at all time points, except for a difference in the American Shoulder and Elbow Surgeons (ASES) elbow function subscale, in favor of CPM, at 6 weeks. The use of CPM decreased swelling and reduced the loss of flexion strength, flexion endurance, and grip strength on day 3, with no between-group differences thereafter. Conclusions: Among patients undergoing arthroscopic release of elbow contracture, those who received CPM obtained a faster recovery and a greater range of motion at 1 year, with a higher chance of restoration of functional elbow motion than those who underwent routine PT. Level of Evidence: Therapeutic Level I . See Instructions for Authors for a complete description of levels of evidence.

Purpose To generate an evidence‐based opioid‐prescribing guideline by assessing the pattern of total opioid consumption and the factors that may predict opioid consumption following arthroscopic release of elbow contracture and to investigate whether the use of continuous passive motion (CPM), as compared to physical therapy (PT), was associated with a decrease in pain and opioid consumption after arthroscopic release of elbow contracture. Methods Data collected from a randomized controlled trial that compared continuous passive motion (CPM) ( n = 24) to physical therapy (PT) ( n = 27) following arthroscopic release of elbow contracture was analyzed for opioid use. Fifty‐one participants recorded their daily opioid consumption in a postoperative diary for 90 days. Multivariate analysis was performed to identify factors associated with opioid use. Recommended quantities for postoperative prescription were generated using the 50th percentile for patients without and the 75th percentile for patients with factors associated with higher opioid use. Results The median total opioid prescription was 437.5‐mg morphine milligram equivalents (MMEs) (58 pills of 5 mg oxycodone) and the median total opioid consumption was 75 MMEs (10 pills of 5‐mg oxycodone). Twenty‐two percent of patients took no opioid medication, 53% took ≤10 pills, 69% took ≤20 pills and 75% took ≤30 pills. Predictors of higher opioid use were preoperative opioid use, age <60 years and inflammatory arthritis. The total opioid consumption appeared similar between the CPM and the PT group. Seventy‐five percent of patient’s home opioid requirements would be satisfied using the following guideline: Patients undergoing contracture release for osteoarthritis or post‐traumatic contracture should be given a prescription for 10 pills of 5 mg oxycodone or its equivalent at discharge. Patients with inflammatory conditions or those taking preoperative opioids should be prescribed 30 pills of 5 mg oxycodone or its equivalent. Conclusion This study suggests that most patients undergoing arthroscopic release of elbow contracture use relatively few opioid pills after surgery. Use of an evidence‐based guideline could decrease opioid prescriptions substantially, while still effectively treating patients’ pain.

Introduction Cutibacterium acnes is a recognized culprit for implant-associated infections, but positive cultures do not always indicate clinically relevant infection. Studies have shown a correlation between the β-hemolytic phenotype of C. acnes and its infectious capacity, but correlation with genetic phylotype has not been performed in literature. The purpose of this study is to evaluate β-hemolysis phenotype, genetic phylotype, and mid-term clinical outcomes of C. acnes isolated from orthopedic surgical sites. Methods Fifty-four C. acnes isolates previously obtained from surgical wounds of patients undergoing hip, knee, shoulder, or spine implant removal were re-cultured. There were 21 females and 33 males with an average age of 59 years (range, 18–84). Twenty-four were from clinically infected sites whereas 30 were considered contaminants. De novo β-hemolysis was analyzed and a retrospective chart review was performed to evaluate clinical outcomes at 7.1 years (range, 0.1–12.8). Results On Brucella agar with 5% rabbit blood, 46% of contaminant and 43% of infectious isolates were hemolytic. Type II phylotype was significantly more nonhemolytic regardless of infectious or contaminant status (p < 0.05). Type 1B correlated with a hemolytic-infectious phenotype and Type 1A with a hemolytic-contaminant phenotype but was not statistically significant. Conclusion The β-hemolytic profile of C. acnes did not correlate with phylotype or clinically relevant orthopedic infection.

Introduction Upper extremity lymphedema can complicate mastectomy, lymph node dissection, and radiation. The purpose of this study is to present the outcomes of shoulder arthroplasty in patients with lymphedema. Methods The 19 shoulders with a shoulder arthroplasty and lymphedema on the surgical side (6 anatomic, 12 reverse, 1 hemiarthroplasty) were followed for four years (1–10 years). There were 2 males and 17 females; average age was 67.8 (48–86) years. Breast carcinoma was the most common reason for lymphedema (75%). A dedicated lymphedema questionnaire could be completed for 14 shoulders. Results Pain improved from moderate or severe preoperatively to no or mild in 18 shoulders. Motion improved in elevation (55° preoperatively, 107° at last follow-up), external rotation (14°, 43°), and internal rotation (sacrum, L5). Complications included an acromion stress fracture with a deep infection (1), deep infection (1), superficial infection (1), and glenoid loosening (1). Lymphedema worsened in nine cases, but worsening was permanent in only four. Currently, lymphedema treatment is being performed by 93% of survey respondents. No patients reported lymphangitis or lymphangiosarcoma. Conclusion Shoulder arthroplasty for an upper extremity with lymphedema provides substantial improvements in pain and motion; however, infection is a concerning complication. Fifty percent of the patients will experience worsening of their lymphedema and in 20% worsening may be permanent.

Background Preoperative planning software has been developed to measure glenoid version, glenoid inclination, and humeral head subluxation on computed tomography (CT) for shoulder arthroplasty. However, most studies analyzing the effect of glenoid positioning on outcome were done prior to the introduction of planning software. Thus, measurements obtained from the software can only be extrapolated to predict failure provided they are similar to classic measurements. The purpose of this study was to compare measurements obtained using classic manual measuring techniques and measurements generated from automated image analysis software. Methods Ninety-five two-dimensional computed tomography scans of shoulders with primary glenohumeral osteoarthritis were measured for version according to Friedman method, inclination according to Maurer method, and subluxation according to Walch method. DICOM files were loaded into an image analysis software (Blueprint, Wright Medical) and the output was compared with values obtained manually using a paired sample t-test. Results Average manual measurements included 13.8° version, 13.2° inclination, and 56.2% subluxation. Average image analysis software values included 17.4° version (3.5° difference, p < 0.0001), 9.2° inclination (3.9° difference, p < 0.001), and 74.2% for subluxation (18% difference, p < 0.0001). Conclusions Glenoid version and inclination values from the software and manual measurement on two-dimensional computed tomography were relatively similar, within approximately 4°. However, subluxation measurements differed by approximately 20%.

Background Substantial proximal humeral bone loss may compromise reverse shoulder arthroplasty secondary to limited implant support, insufficient soft tissue tension due to shortening, lack of attachment sites for the posterosuperior cuff when present, and lack of lateral offset of the deltoid. In these circumstances, use of a proximal humeral replacement may be considered. Patients/Methods Between 2012 and 2014, 34 consecutive reverse shoulder arthroplasties were performed using a proximal humeral replacement system. The indications were failed shoulder arthroplasty (15), oncology reconstruction (9), humeral malunion/nonunion (7), prior resection arthroplasty (2), and intraoperative fracture (1). All patients were included in the survival analysis. Twenty-two patients with minimum 2-year follow-up were included in analysis of clinical results. Results Among the cohort of 34 patients, there were 8 additional reoperations: humeral loosening (3), periprosthetic fracture (2), irrigation and debridement (2), and glenoid loosening (1). Humeral component loosening occurred exclusively in patients undergoing revision shoulder arthroplasty. The 4 patients had an average 3.75 prior procedures before the proximal humeral replacement. Two of the revisions were from cemented to uncemented stems. Among the 23 patients with minimum 2-year follow-up, there was significant improvement in pain scores (4.1 vs 0.6), forward elevation (31 vs 109) degrees, and 81% were satisfied. Conclusion Use of a proximal humeral replacement when performing a reverse shoulder arthroplasty in the complex setting of substantial proximal humerus bone loss provides good clinical results and a particularly low dislocation rate. However, the rate of loosening of the humeral component in the revision setting suggests that proximal humeral replacement components should be cemented when revising a previously cemented stem. IRB 16-006966.

Background Glenoid morphology, glenoid version and humeral head subluxation represent important parameters for the treating physician. The most common method of assessing glenoid morphology is the Walch classification which has only been validated with computed tomography (CT). Methods CT images and magnetic resonance imaging (MRI) images of 25 patients were de-identified and randomized. Three reviewers assessed the images for each parameter twice. The Walch classification was assessed with a weighted kappa value. Glenoid version and humeral head subluxation were comparted with a reproducibility coefficient. Results The Walch classification demonstrated almost perfect intraobserver agreement for MRI and CT images (k = 0.87). Weighted interobserver agreement values for the Walch classification were fair for CT and MRI (k = 0.34). The weighted reproducibility coefficient for glenoid version measured 9.13 (CI 7.16–12.60) degrees for CT and 13.44 (CI 10.54–18.55) degrees for MRI images. The weighted reproducibility coefficient for percentage of humeral head subluxation was 17.43% (CI 13.67–24.06) for CT and 18.49% (CI 14.5–25.52) for MRI images. Discussion CT and MRI images demonstrated similar efficacy in classifying glenoid morphology, measuring glenoid version and measuring posterior humeral head subluxation. MRI can be used as an alternative to CT for measuring these parameters.