Citations

Purpose To determine the contribution of the ligamentum teres (LT) to hip stability in the presence of an intact capsule with special attention to the change in range of motion and femoral head translation. Methods Seven fresh‐frozen cadaveric pelvises were used. Following visual inspection of the LT at different hip positions, internal rotation angles were measured at 10° of extension and at 0° of flexion, while external rotation was measured at 60°, 90°, and 110° of flexion with different hip abduction angles using electromagnetic motion tracking sensor. Femoral head translations were measured simultaneously. The tests were repeated after resection of the LT. The capsule was left intact for all test conditions. The results were compared between intact and LT resected conditions when torque of 2 and 4 Nm was applied. Results Compared with the intact hip, the LT resected hip showed no significant difference when 2 Nm torque was applied in all scenarios. With 4 Nm torque application, significant increase in external rotation was found at 60° and at 90° of flexion (1.7° ± 0.8° and 2.1° ± 1.0°, respectively). Significant difference was also noted at 60°, 90°, and 110° of flexion when the hip was in the adducted position while at 90° in the abducted hip. However, LT resection did not show significant change in internal rotation. There was no significant difference in the translation distance of the femoral head in the intact hip compared with the LT resected hip (0.77‐1.11 mm vs 0.79‐1.29 mm). Conclusions Our results indicate that within the physiologic range of motion, LT can minimally limit external rotation when the hip is in the flexed position but does not contribute to translation stability. Clinical Relevance In the hip with intact capsule, LT deficiency can result in a slight increase in range of motion, but its contribution to stability is questionable.

ABSTRACT Carpal tunnel pressure is a key factor in the etiology of carpal tunnel syndrome. Numerous approaches have been conducted to measure carpal tunnel pressure. However, most techniques are invasive and take time and effort. We have developed an innovative approach to noninvasively assess the tunnel pressure by using the ultrasound surface wave elastography (USWE) technique. In a previous study it was shown that the shear wave speed in a tendon increased linearly with increasing tunnel pressure enclosed the tendon in a simple tendon model. This study aimed to examine the relationship between the carpal tunnel pressure and the shear wave speeds inside and outside the carpal tunnel in a human cadaveric model. The result showed that the shear wave speed inside the carpal tunnel increased linearly with created carpal tunnel pressure, while the shear wave speed outside the carpal tunnel remained constant. These findings suggest that noninvasive measurement of carpal tunnel pressure is possible by measuring the shear wave speed in the tendon. After fully establishing this technology and being applicable in clinic, it would be useful in the diagnosis of carpal tunnel syndrome. For that reason, further validation with this technique in both healthy controls and patients with carpal tunnel syndrome is required. © 2017 Orthopaedic Research Society. Published by Wiley Periodicals, Inc. J Orthop Res 36:477–483, 2018.

Background The stabilizing role of the deltoid muscle has not been extensively studied. Purpose To study the contribution of the deltoid muscle to anterior stability of the shoulder. Study Design Controlled laboratory study. Methods We used nine fresh cadaveric shoulders with the arm at 90° of abduction and 90° of external rotation. The position of the humeral head was monitored by an electromagnetic tracking device with 0 and 1.5 kg of anterior translation force; with 0, 1, 3, and 5 kg of force applied to each of the anterior, middle, and posterior portions of the deltoid muscle; and with the capsule intact, vented, and with a simulated Bankart lesion. Results With the capsule intact, anterior displacement was significantly reduced by application of load to the middle deltoid muscle. After the capsule was vented, load application to the anterior, middle, or posterior deltoid muscle significantly reduced anterior displacement. With a simulated Bankart lesion, effects of muscle loading were most apparent: anterior displacement was significantly reduced with loading of each muscle portion. Conclusion The deltoid muscle is an anterior stabilizer of the glenohumeral joint with the arm in abduction and external rotation. Clinical Relevance The stabilizing function of the deltoid muscle takes on more importance as the shoulder becomes unstable.

Normative data are useful for assessing isometric shoulder strength in patients with bilateral shoulder abnormalities. The purpose of this study was to develop a normative database for shoulder strength in the clinically relevant positions and movements. Twenty combinations of exertions and postures—including flexion, extension, abduction, adduction, internal rotation, and external rotation—were tested for both the dominant and nondominant sides. Strength was measured isometrically using a modified Cybex II dynamometer. The cross-sectional study design included 120 subjects (60 women and 60 men) ranging in age from 20 to 78 years from southern Minnesota. Tables of normative strength data were constructed. Multivariate analyses were performed to assess the effect of age, sex, and weight on strength. Age was negatively associated with all strength measures, and weight was positively associated with them. Men were stronger than women when controlling for age and weight. Statistically significant differences between dominant and nondominant shoulders were found for only some of the strength measures taken. These normal data will be useful to the clinician, as they permit a standard against which to compare shoulder strength.

Background An anteroinferior osseous defect of the glenoid rim is sometimes encountered in patients with recurrent anterior dislocations of the shoulder. A defect of more than 21% of the glenoid length is reported to cause instability after Bankart repair. Hypothesis We can estimate the critical size of glenoid defects by using radiography or computed tomography. Study Design A controlled laboratory study. Methods Osseous defects of 0%, 9%, 21%, 34%, and 46% of the glenoid length were created stepwise in 12 cadaveric scapulae, and plain radiographs simulating the axillary and West Point views and computed tomographic images were obtained. The maximum width of the remnant glenoid was measured under each condition and expressed as a percentage of the width of the intact glenoid. Results A 21% defect appeared to be 18.6% of the intact glenoid on the West Point view. With computed tomography, a 21% defect resulted in loss of 50% of the width on a single slice across the lower one-fourth of the glenoid. Conclusions We can estimate the size of a glenoid defect by using the West Point radiographic view or computed tomogram. Clinical Relevance These images gave decisive information as to whether an osseous glenoid defect required bone grafting to achieve stability after Bankart repair.

AbstractSubstance P (SP), a neurotransmitter released after injury, has been linked to deregulated tissue repair and fibrosis in musculoskeletal tissues and other organs. Although SP inhibition is an effective treatment for nausea, it has not been previously considered as an anti‐fibrotic therapy. Although there are extensive medical records of individuals who have used SP antagonists, our analysis of human registry data revealed that patients receiving these antagonists and arthroplasty are exceedingly rare, thus precluding a clinical evaluation of their potential effects in the context of arthrofibrosis. Therefore, we pursued in vivo studies to assess the effect of SP inhibition early after injury on pro‐fibrotic gene expression and contractures in an animal model of post‐traumatic joint stiffening. Skeletally mature rabbits (n = 24) underwent surgically induced severe joint contracture, while injected with either fosaprepitant (a selective SP antagonist) or saline (control) early after surgery (3, 6, 12, and 24 h). Biomechanical testing revealed that differences in mean contracture angles between the groups were not statistically significant (P = 0.27), suggesting that the drug neither mitigates nor exacerbates joint contracture. However, microarray gene expression analysis revealed that mRNA levels for proteins related to cell signaling, pro‐angiogenic, pro‐inflammatory, and collagen matrix production were significantly different between control and fosaprepitant treated rabbits (P < 0.05). Hence, our study demonstrates that inhibition of SP alters expression of pro‐fibrotic genes in vivo. This finding will motivate future studies to optimize interventions that target SP to reduce the formation of post‐traumatic joint contractures.

ABSTRACTIntroduction: Rotator cuff (RC) tears result in muscle atrophy and fat infiltration within the RC muscles. An estimation of muscle quality and deformation, or extensibility, is useful in selecting the most appropriate surgical procedure. We determined if noninvasive quantitative assessment of intramuscular fat using MRI could be used to predict extensibility of the supraspinatus muscle. Methods: Seventeen cadaveric shoulders were imaged to assess intramuscular fat infiltration. Extensibility and histological evaluations were then performed. Results: Quantitative fat infiltration positively correlated with histological findings and presented a positive correlation with muscle extensibility (r = 0.69; P = 0.002). Extensibility was not significantly different between shoulders graded with a higher fat content versus those with low fat when implementing qualitative methods. Discussion: A noninvasive prediction of whole‐muscle extensibility may directly guide pre‐operative planning to determine if the torn edge could efficiently cover the original footprint while aiding in postoperative evaluation of RC repair. Muscle Nerve 57: 129–135, 2018

The purpose of this study was to assess the correlations of acceleration measurements between an instrumented hockey helmet and the Hybrid III headform and to determine whether collision with a broad surface affects the correlations between these data. A CCM Vector hockey helmet, instrumented with the Head Impact Telemetry System, was fitted onto an instrumented Hybrid III headform and dropped onto an inclined plate to simulate impacts in hockey. The helmet and headform were dropped from 0.15, 0.30, and 0.60 m at different orientations to create impacts to the vertex, occipital, right, left, and forehead surfaces. Peak linear and rotational acceleration magnitudes and head injury criteria were assessed for each system. Correlations were assessed with the Pearson correlation coefficient, and linear regression models were generated. Relative error was assessed, and results were compared with the Wilcoxon signed rank test. Peak acceleration magnitudes generally had strong mathematical correlations, although a 1:1 linear relationship for rotational acceleration data was not observed. Differences between helmet and head peak acceleration magnitudes were significant. The linear relationship varied according to the impact direction. Instrumented helmet and head data demonstrated a strong mathematical correlation, but measures of linear acceleration generally had better 1:1 agreement than rotational acceleration measures. There is some dependence in the relationship between the helmet and head data on the impact direction, with vertex strikes showing the weakest correlation. Although data generated from the helmet may be useful for interpreting head accelerations experienced by on-ice players, additional analysis of the time-series data should be performed to understand its full utility.