Cytoskeletal remodeling in smooth muscle occurs with activation and involves actin polymerization. Remodeling of the cortical cytoskeleton allows tethering of contractile proteins and force transmission to the extracellular matrix. Smooth muscle contraction involves cross‐bridge cycling and ATP hydrolysis, which are both sensitive to loading. During isometric activation, the rate of ATP hydrolysis is initially high but declines with time reaching a steady‐state, while peak force is maintained. Thus, tension cost, i.e., the rate of ATP hydrolysis per unit of force, decreases over time, reflecting increased efficiency of smooth muscle activation. We hypothesize that the time‐dependent decrease in ATP hydrolysis rate and tension cost is due to cytoskeletal remodeling and an increase in internal loading on cross‐bridges. In permeabilized porcine airway smooth muscle (ASM) strips, isometric force and ATP hydrolysis rate were simultaneously measured after maximum Ca 2+ activation (pCa 4.0). From each animal, two ASM strips were tested: 1) Inhibition of actin polymerization and cytoskeletal remodeling using Cytochalasin‐D (Cyto‐D; treated (1 μM for 30 min); and 2) Untreated controls. Compared to untreated controls, Cyto‐D‐induced inhibition of actin polymerization reduced both peak and steady‐state isometric force by ~40%, while peak and steady‐state ATP hydrolysis rate increased by ~30% and ~20%, respectively. As a result, at peak and steady‐state, tension cost increased by ~100% and ~60%, respectively, following Cyto‐D treatment. These results support our hypothesis that the time‐dependent decrease in ATP hydrolysis rate reflects an increase in internal load on cross‐bridges via cytoskeletal remodeling. Cyto‐D inhibition of cytoskeletal remodeling impairs contractile protein tethering and thus reduces internal loading, resulting in faster cross‐bridge cycling and increased ATP hydrolysis rate. Support or Funding Information Supported by NIH grant HL126451(GCS), HL150890 (GCS) and the Mayo Clinic