Growney, Eríc S.

Material properties of the plantar aponeurosis were determined by a two-dimensional video tracking method to simultaneously measure the aponeurosis deformation. Failure loads averaged 1189 ± 244 N and were higher in men. Average stiffness of the intact fascia was 203.7 ± 50.5 N/mm at a loading rate of 11.12 N/sec and it did not vary significantly for the loading rates of 11.12 to 1112 N/sec. The high tensile loads required for failure were consistent with clinical and biomechanical studies and indicated the importance of the aponeurosis in foot function and arch stability.

The purpose of this study was to analyze intersegmen tal forces at the tibiofemoral joint and muscle activity during three commonly prescribed closed kinetic chain exercises: the power squat, the front squat, and the lunge. Subjects with anterior cruciate ligament-intact knees performed repetitions of each of the three exer cises using a 223-N (50-pound) barbell. The results showed that the mean tibiofemoral shear force was posterior (tibial force on femur) throughout the cycle of all three exercises. The magnitude of the posterior shear forces increased with knee flexion during the descent phase of each exercise. Joint compression forces remained constant throughout the descent and ascent phases of the power squat and the front squat. A net offset in extension for the moment about the knee was present for all three exercises. Increased quadri ceps muscle activity and decreased hamstring muscle activity are required to perform the lunge as compared with the power squat and the front squat. A posterior tibiofemoral shear force throughout the entire cycle of all three exercises in these subjects with anterior cru ciate ligament-intact knees indicates that the potential loading on the injured or reconstructed anterior cruci ate ligament is not significant. The magnitude of the posterior tibiofemoral shear force is not likely to be detrimental to the injured or reconstructed posterior cruciate ligament. These conclusions assume that the resultant anteroposterior shear force corresponds to the anterior and posterior cruciate ligament forces.

This study compared and quantified electromyographic muscle activation of the rotator cuff with the isometric torque generated by performing shoulder rotation in various positions. Twenty healthy volunteers were tested in 29 shoulder positions. Using a Cybex II dy namometer synchronously with electromyography, surface electrodes were placed over the pectoralis major muscle and three parts of the deltoid muscle. Intramuscular wire electrodes were inserted into the four rotator cuff muscles. We found that the greatest external rotation isometric force is generated in the frontal and scapular planes in the neutral or full internal rotation positions. The sagittal, dependent, and the scapular plane with 45° of elevation in rotational posi tions of either full or half external rotation generated the greatest torques for internal rotation isometric force. The rotator cuff muscles generated greatest electro myographic activity in neutral to midrotational posi tions. The scapular plane with 90° of shoulder eleva tion in neutral rotation best isolated the subscapularis muscle. The infraspinatus-teres minor muscles were isolated in the sagittal plane with 90° of shoulder ele vation in a half externally rotated position. We were unable to isolate the supraspinatus muscle in any of these tested positions. These positions are recom mended for manual muscle testing and for strengthen ing these muscles.