Berthonnaud, Éric

A three-dimensional (3D) geometric model for predicting muscle forces in the shoulder complex is proposed. The model was applied throughout the range of arm elevation in the scapular plan. In vitro testing has been performed on 13 cadaveric shoulders. The objectives were to determine homogeneous values of physiological parameters of shoulder muscles and to locate sites of muscular attachment to any bone of the shoulder complex. Muscular fiber lengths, lengths of contractile element (CE), and muscle volumes were measured, corresponding physiological cross-sectional area (PCSA) were calculated, and force/length muscle relations were found. An in vivo biplanar radiography was performed on five volunteers. The photogrammetric reconstruction of bone axes and landmarks were coupled with a geometric modeling of bones and muscle sites of attachment. Muscular paths were drawn and changes in lengths during movement have been estimated. Directions of muscle forces are the same as that of muscular path at the point of attachment to bone. Magnitudes of muscular forces were found from muscle lengths coupled with force/length relations. Passive forces were directly determined contrary to active muscle forces. A resulting active muscle force is calculated from balancing weight and passive forces at each articular center. Active muscle forces were calculated by distributing the resulting force among active muscles based on the muscular PCSA values.

In biomechanics, the knowledge of accurate location of a joint center is essential because equilibration of the external loads and muscular forces about the joint is performed about this specific point. This paper focuses on the location of centers of gleno-humeral joint and scapulo-thoracic joint in a subject moving their arm in the scapular plane with a magnitude of 120°. Biplanar radiography with successive exposures has been used locating anatomical axes of bones. Geometric models of bones were defined allowing access to bone morphology by superposing model projections onto X-ray imaged bone contours. Functional models were used so as to represent the behavior in motion of shoulder joints. These techniques allowed us to access to results describing the linear and angular relative displacements of the shoulder bones between two different postures. The gleno-humeral and scapulo-thoracic finite joint centers (F H and F S ) are first defined through the location of the corresponding helical axis of motion (HAM) moving the joint from positions occupied in initial and final postures. The gleno-humeral and scapulo-thoracic mean joint centers (M H and M S ) are then calculated using a new technique, which defines that each joint center has the point having the smallest migrations while moving continuously from initial to final postures. This allows for the analysis of the linear and angular clearances, which affect joint center migration. The whole continuous movement has been parsed into several steps to test the stability of the mean joint center throughout the motion.