AbstractMammographic percent density (PD) is a strong risk factor for breast cancer, but there has been relatively little systematic evaluation of other features in mammographic images that might additionally predict breast cancer risk. We evaluated the association of a large number of image texture features with risk of breast cancer using a clinic-based case-control study of digitized film mammograms, all with screening mammograms before breast cancer diagnosis. The sample was split into training (123 cases and 258 controls) and validation (123 cases and 264 controls) data sets. Age-adjusted and body mass index (BMI)–adjusted odds ratios (OR) per SD change in the feature, 95% confidence intervals, and the area under the receiver operator characteristic curve (AUC) were obtained using logistic regression. A bootstrap approach was used to identify the strongest features in the training data set, and results for features that validated in the second half of the sample were reported using the full data set. The mean age at mammography was 64.0 ± 10.2 years, and the mean time from mammography to breast cancer was 3.7 ± 1.0 (range, 2.0-5.9 years). PD was associated with breast cancer risk (OR, 1.49; 95% confidence interval, 1.25-1.78). The strongest features that validated from each of several classes (Markovian, run length, Laws, wavelet, and Fourier) showed similar ORs as PD and predicted breast cancer at a similar magnitude (AUC = 0.58-0.60) as PD (AUC = 0.58). All of these features were automatically calculated (unlike PD) and measure texture at a coarse scale. These features were moderately correlated with PD (r = 0.39-0.76), and after adjustment for PD, each of the features attenuated only slightly and retained statistical significance. However, simultaneous inclusion of these features in a model with PD did not significantly improve the ability to predict breast cancer. (Cancer Epidemiol Biomarkers Prev 2009;18(3):837–45)
CAD of colon cancer on CT colonography cases without cathartic bowel preparation
2008 30th Annual International Conference of the IEEE Engineering in Medicine and Biology Society | February 2, 2009 | Volume: No volume available | Issue: No issue available | Pages: 2996-2999
A nuclear magnetic resonance imaging (MRI) method is presented for quantitatively mapping the physical response of a material to harmonic mechanical excitation. The resulting images allow calculation of regional mechanical properties. Measurements of shear modulus obtained with the MRI technique in gel materials correlate with independent measurements of static shear modulus. The results indicate that displacement patterns corresponding to cyclic displacements smaller than 200 nanometers can be measured. The findings suggest the feasibility of a medical imaging technique for delineating elasticity and other mechanical properties of tissue.