Citations

We defined the relative contributions of six ligaments in stabilizing the arch of the foot: plantar aponeurosis, long-short plantar ligaments, plantar calcaneonavicular ligament (spring ligament), medial talocalcaneal ligament, talocalcaneal interosseous ligament, and tibionavicular portion of the deltoid ligament. Nineteen fresh-frozen human foot specimens were used. A load of 445 N was applied axially to simulate standing-at-ease posture. Three-dimensional positions of tarsal bones before and after ligament sectioning were determined with the use of a magnetic tracking device. The motions were presented in the form of screw axis displacements, quantitating rotation, and axis of rotation orientation. After sectioning one structure, the arch did not collapse on any specimen and there was no obvious change by visual inspection. There were, however, measurable changes in tarsal bone position. Metatarsal-to-talus total rotation difference was greatest with spring ligament and deltoid ligament sectioning, with an average of 2.1° ± 1.7° and 2.0° ± 0.2° difference, respectively. Calcaneus-to-talus rotation difference was greatest with talocalcaneal interosseous ligament sectioning, with an average of 1.7° ± 1.5°. The spring ligament, deltoid ligament, and talocalcaneal interosseous ligament were most important for arch stability.

Ligaments surrounding the hindfoot joints play an important role in hindfoot stability. This in vitro study investigated anatomical and biomechanical characteristics of nine major ligamentous structures, including length and orientation at neutral position and physiological elongation with the foot in five different positions relative to the neutral position. The results showed that ligament elongation depended on the ligament length, orientation in neutral position, and movement of bones to which they were attached.

We studied six fresh frozen cadaver feet to define the three-dimensional motion of the hallux proximal phalanx in relation to the first metatarsal and to describe the contact features of the first metatarsophalangeal joint. Six tendons to the hallux were loaded to simulate dynamic loading of the hallux. A magnetic tracking system was used to monitor the three-dimensional movement of the proximal phalanx while the toe position was changed from a neutral position to full extension by adjusting the tendon loads. The average surface area was 0.38 ± 0.08 cm 2 in the neutral position; it decreased with toe extension and was the lowest (0.04 ± 0.03 cm 2 ) at the full extension position. Contact distribution of the proximal phalanx did not change substantially throughout the arc of motion. However, for the metatarsal articular surface, the contact distribution shifted dorsally with increasing degrees of extension. These data are consistent with the observation that chondral erosions associated with hallux rigidus and degenerative arthritis initially affect the dorsal articular surface of the metatarsal, and implant arthroplasty often fails from component loading dorsally. The current technique of determining joint contact characteristics is applicable not only for the first metatarsophalangeal joint but also other joints that have not been studied because of shortcomings with more conventional methods.

A cadaver study was performed to determine the effect of the posterior tibial tendon (PTT) on the stability of the foot in simulated midstance phase of gait. Thirteen fresh-frozen human foot specimens were used. Loads were applied axially and to each tendon. Three-dimensional positions of tarsal bones before and after tendon loading were determined with the use of a magnetic tracking device. Significant differences in tarsal bone positions were observed with application of loads to the Achilles, posterior tibial, flexor digitorum longus, peroneus longus, and peroneus brevis tendons at the metatarsotalar, calcaneotalar, and talotibial joints and in overall arch height. These tendon loads caused position changes toward arch flattening or mild pes planus deformity. Significant differences in tarsal bone positions were observed with PTT loading compared with no PTT loading in metatarsotalar, calcaneotalar, and talotibial levels as well as arch height. The PTT caused position changes toward restoring the arch alignment. These data suggest that the PTT is an important stabilizer of the arch of the foot.

The change in position of the bones of the foot was studied in three dimensions after plantar fascia release in intact and destabilized feet. Fifteen fresh-frozen human foot specimens were used. Physiologic loads of 445 newtons were applied axially to simulate standing at ease, and the three-dimensional position of tarsal bones was determined with a magnetic tracking device. The positions were presented in the form of screw axis displacements, quantitating rotation, and axis of rotation orientation. After fasciotomy in the six intact feet, significant differences in rotation were observed at the talotibial and calcaneotalar levels. After fasciotomy in the four unstable feet with three supporting elements sectioned, significant differences in position were observed at the talotibial joint and a significant decrease in arch height was observed. After fasciotomy in the five unstable feet with five supporting elements sectioned, significant differences in rotation were observed at the talotibial joint (mean, 5.5 ± 1.6° P = 0.001), calcaneotalar joint (mean, 6.1 ± 2.1° P = 0.003), and metatarsotalar level (mean, 9.3 ± 4.1° P = 0.007). The average decrease in arch height was 7.4 ± 4.1 mm ( P = 0.015). Displacement of all joints tested occurred after fasciotomy, with rotation about all three axes. These changes in displacement were more pronounced in unstable or destabilized feet. The data suggest that operations involving fasciotomy affect arch stability and should not be performed in patients with evidence of concomitant pes planus deformity, because of the likelihood of further deformation.

We studied 15 cadaver feet to determine three-dimensional motion of selected tarsal bones under axial loading at three different loading levels. We determined the motion of individual joints and also the rotation of the tarsal bones in relation to the tibia. Joint rotations increased consistently with higher loads. The navicular-talar joint had the greatest total screw axis rotation, which averaged 9.4° ± 2.2° at 667 N of load, followed by the first metatarsal-navicular (mean, 7.2° ± 1.5°), talar-tibial (mean, 5.2° ± 1.6°), and calcaneal-talar (mean, 4.4° ± 1.7°) joints. The observed changes indicate the need for assessment of foot and ankle alignment clinically and radiologically while the patient is weightbearing.

Material properties of the plantar aponeurosis were determined by a two-dimensional video tracking method to simultaneously measure the aponeurosis deformation. Failure loads averaged 1189 ± 244 N and were higher in men. Average stiffness of the intact fascia was 203.7 ± 50.5 N/mm at a loading rate of 11.12 N/sec and it did not vary significantly for the loading rates of 11.12 to 1112 N/sec. The high tensile loads required for failure were consistent with clinical and biomechanical studies and indicated the importance of the aponeurosis in foot function and arch stability.

There is very little data addressing cartilage response to tensile forces, and no literature attempts to correlate compressive with tensile modalities. Our hypothesis was that the cyclic compression and tension modulate chondrocyte matrix proteoglycan synthetic response differently. Porcine chondrocytes cultured to confluence on a flexible membrane were subjected to cyclic compression (Group A: 13 KPa at 1 Hz) or tension (Group C: 10% strain at 1 Hz) for 16 or 32 h; while controls not subjected to any force were kept (Group B). The chondrocytes were then stained with alcian blue and stained areas quantified with confocal microscopy and image processing software. Two-factor ANOVA with post-hoc tests (Scheffe and Bonferroni) statistical analysis were used. Proteoglycan staining covered 46% (range 28%–61%) and 39% (range 26%–49%) of the surface area following 32 and 16 h of compression respectively, 23% (range 15%–49%) for control, and 19% (range 10%–29%) and 16% (range 9%–25%) following 16 and 32 h tension respectively. Proteoglycan content following all compressions was significantly greater than with cyclic tension or control (p < 0.0001). Our data demonstrate that chondrocytes cultured in vitro respond to compression distinctly different from tension and that it is highly sensitive to mechanical loading, with rapid adaptation to its mechanical environment. These results imply that cartilage grown in culture, with the intention of transplantation, may structurally benefit from an environment of cyclic loading at higher frequencies.

Background: We performed a laboratory-based study of the ankle-hindfoot complex in normal cadaveric ankles with simulated lateral ankle ligament injuries, utilizing an ankle stability testing device. The ankle stability testing device distinguished between intact, injury to anterior talofibular ligament (ATFL) and combined injury to ATFL and calcaneofibular ligament (CFL). Materials and Methods: Ankles were tested in an ankle stability testing device, with a specified inversion torque applied through the range of sagittal plane motion, then internal rotation torque applied through the entire range of sagittal plane motion. Three-dimensional motion of the calcaneus and talus in relation to the tibia were determined with a magnetic tracking system. The specimens were tested in the intact condition, then after sectioning the ATFL, then the CFL. Results: Upon sectioning the ATFL, there was a significant increase in the internal rotation motion at the tibiotalar joint. Subsequent sectioning of the CFL did not significantly increase ankle-hindfoot internal rotation, but it did significantly increase the motion in inversion testing. This increase occurred primarily at the tibiotalar level. Conclusion: The isolated ATFL injury was clearly distinguished from the intact condition by increased talar-tibial internal rotation, but not inversion. The more severe combined ATFL/CFL injury was distinguished from the ATFL injury condition with inversion torque. Clinical Relevance: Inversion torque may disclose combined ATFL/CFL injury, and internal rotation torque may be the key to distinguish isolated ATFL and combined ATFL/CFL injuries.

ABSTRACT Gene transfer vectors containing adenovirus (Ad) serotype 35 (Ad35) fibers have shown promise for cancer and stem cell gene therapy. In this study, we attempted to improve the in vitro and in vivo infection properties of these vectors by increasing their affinity to the Ad35 fiber receptor CD46. We constructed Ad vectors containing either the wild-type Ad35 fiber knob (Ad5/35) or Ad35 knob mutants with 4-fold- and 60-fold-higher affinity to CD46 (Ad5/35+ and Ad5/35++, respectively). In in vitro studies with cell lines, the higher affinities of Ad5/35+ and Ad5/35++ to CD46 did not translate into correspondingly higher transduction efficiencies, regardless of the CD46 receptor density present on cells. However, in vivo, in a mouse model with preestablished CD46 high liver metastases, intravenous injection of Ad5/35++ resulted in more-efficient tumor cell transduction. We conclude that Ad5/35 vectors with increased affinity to CD46 have an advantage in competing with non-CD46-mediated sequestration of vector particles after intravenous injection.