Rizzo, Marco

Background: Little is known about how silicone metacarpophalangeal (MCP) arthroplasty outcomes compare between rheumatoid arthritis (RA) and osteoarthritis (OA) patients. Methods: Using our single institutional data from 2000 to 2022, we propensity matched 46 primary silicone MCP arthroplasties in 33 OA patients 1:2 to 92 arthroplasties in 54 RA patients based on age, sex, body mass index, operative digit, and if the surgery was on the dominant hand. We used Kaplan-Meier estimates and cluster-robust Cox proportional hazard models to compare survival free from revision, all-cause reoperation, and development of coronal plane deviation >10°. Results: There was comparable 10-year survival free of revision (94% OA, 91% RA) and all-cause reoperation (91% OA, 87% RA), with no difference in risk for each outcome between groups. Revision in OA patients occurred early (mean 0.6 years) for recurrent deformity (n = 2) and periprosthetic joint infection (n = 1). Revision in the RA cohort occurred later (mean 6.3 years postoperatively) for recurrent deformity (n = 3) and dislocation (n = 1). Osteoarthritis patients had less coronal plane deviation at the final radiographic follow-up (6.5° vs 16.2°, P < .001), higher 10-year survival free from coronal deviation > 10° (79% vs 17%), and lower risk of progressive coronal deformity (hazard ratio 0.15, P < .001). Conclusions: Silicone MCP arthroplasty remains a durable option with low reoperation rates for RA and OA. Osteoarthritis patients experience less coronal deviation and late reoperation for deformity than RA patients, likely due to their more robust soft-tissue stabilizers and noninflammatory disease process.

AbstractThumb carpometacarpal (CMC) arthritis is a common and sometimes debilitating condition with a variety of surgical treatments. Pyrocarbon thumb CMC hemiarthroplasty is one option, which has demonstrated promise; however, no long-term outcomes have been reported.We performed a retrospective institutional review of 106 primary thumb CMC pyrocarbon hemiarthroplasties with a minimum of 1 year, median 6.1-year follow-up. We analyzed rates of pain relief, reoperation, and implant failure as well as biomechanical, radiographic, and patient-reported outcomes.Pain was significantly decreased after surgery. Radial and palmar abduction were modestly improved postoperatively (increased from 40–50 degrees). Implants showed high rates of radiographic osteolysis (53%) and subsidence (44%). Two-, 5-, and 10-year rates of reoperation (18, 21, 21%) and implant removal (15, 19, and 19%), respectively.Pyrocarbon thumb CMC hemiarthroplasty provides high rates of pain relief and preservation of pinch and grip strength. Patients had modest improvement in radial and palmar abduction; however, hemiarthroplasty was associated with moderate rates of reoperation and implant revision.Therapy Level IV.

Background: Flexor pollicis longus (FPL) palsy following both-bone forearm fracture (BBFF) is a rare complication. Methods: A retrospective review of acute BBFF treated with open reduction internal fixation by a single surgeon from 2005 to 2023 was performed. Injury and surgical characteristics of patients with documented FPL palsy were reviewed. In addition, 10 cadaveric dissections were performed to evaluate the anatomy of the anterior interosseous nerve (AIN) and its branches. The distance of these branches from palpable elbow landmarks and variability in branching pattern were evaluated. Results: Twenty-nine patients underwent surgery for acute BBFF. Of these, 5 (17%) had evidence of an FPL palsy either at the time of injury presentation (n = 2) or immediately following surgery (n = 3). All patients with FPL palsy sustained fractures in the middle one-third of the radius. All palsies resolved after an average of 33 days of observation. In cadaveric dissections, the average distance from the lateral epicondyle to the AIN takeoff and branch to the FPL was 5.5 and 7.6 cm, respectively. The AIN takeoff and branch to the FPL were never less than 4 and 7 cm from the lateral epicondyle, respectively. Conclusion: Flexor pollicis longus palsy following BBFF can occur at the time of injury or following surgery. All FPL palsies involved midshaft radial fractures and were likely neurapraxia. The etiology of FPL palsy remains unclear, but cadaveric dissection suggests the FPL motor branch may be at risk from mid-to-proximal radius fracture fragments or excessive traction during surgery.

Chronic proximal interphalangeal (PIP) joint instability is a rare and difficult problem to treat, with the main options including collateral ligament reconstruction and joint arthrodesis. To date, there are minimal described techniques for collateral ligament reconstruction. We describe a novel technique utilizing a slip of the flexor digitorum superficialis (FDS), harvested through a single minimal incision. This technique can be used for collateral ligament reconstruction with multiple applications, including chronic recurrent PIP joint dislocations and instability during PIP joint arthroplasty.

Abstract The purpose of this study was to assess the long-term clinical and radiographic outcomes after distal ulna resection (Darrach procedure) in young adults. A retrospective chart review identified all adult patients who underwent Darrach resection at 40 years of age or younger and had a minimum of 5-year follow-up. Twenty-one patients (24 wrists) were available for final follow-up. Fifteen patients (16 wrists) returned for in-person evaluation, and seven patients (eight wrists) completed questionnaires by phone. Mean PRWE and QuickDASH scores were 32 and 34, respectively. The median visual analog scale at rest was 0 and 1 with activity. In 88% of cases, patients reported they would have the same surgery again. Of those who were employed preoperatively, 81% (13/16) returned to work, with all but one patient returning to their preoperative job. Radioulnar convergence occurred in all patients, but only three (23%) were symptomatic. The Darrach procedure may be a viable surgical option for DRUJ pathology in younger adults when other options are unavailable. Therapeutic IV.

Background: Surgical management of failed metacarpophalangeal (MCP) arthroplasties includes revision arthroplasty and arthrodesis. The purpose of this study was to review the indications and outcomes of arthrodesis as a salvage procedure for failed MCP arthroplasties. Methods: This was a retrospective cohort study of all patients undergoing salvage MCP arthrodesis at a single institution from 1990 to 2020. Patient charts were reviewed for patient demographics, indication for salvage, surgical technique, revision rate, and time to radiographic union. Patient-reported outcomes, including the Michigan Hand Outcomes Questionnaire and an MCP-specific questionnaire detailing pain, functional, appearance, and patient satisfaction, were also collected. Results: Eleven digits in 9 patients (6 women, 3 men, median age of 66) with median 36-month follow-up were included. The majority (91%) of patients also had concomitant soft tissue deformities, including joint contractures, extension lag, and collateral ligament insufficiency. The overall revision rate following arthrodesis was 45% with 3 digits requiring one revision each, and 2 digits undergoing 3 revisions. The overall union rate was 91% with median time to union of 4 months from most recent arthrodesis. Patient-reported outcomes obtained from 4 patients demonstrated improvements in pain and function. Conclusion: Despite a high revision rate of 45%, salvage MCP arthrodesis following arthroplasty has a high eventual union rate of 91% and is associated with improved pain and function based on 4 patients’ experiences. Arthrodesis as a salvage procedure for failed MCP arthroplasties should be considered in patients with persistent joint instability and functionally limiting soft tissue deformities.

Abstract The scaphotrapeziotrapezoid (STT) joint is involved in load transmission between the wrist and thumb. A quantitative description of baseline STT joint morphometrics is needed to capture the variation of normal anatomy as well as to guide staging of osteoarthritis. Statistical shape modeling (SSM) techniques quantify variations in three‐dimensional shapes and relative positions. The objectives of this study are to describe the morphology of the STT joint using a multi‐domain SSM. We asked: (1) What are the dominant modes of variation that impact bone and articulation morphology at the STT joint, and (2) what are the morphometrics of SSM‐generated STT joints? Thirty adult participants were recruited to a computed tomography study of normal wrist imaging and biomechanics. Segmentations of the carpus were converted to three‐dimensional triangular surface meshes. A multi‐domain, particle‐based entropy system SSM was used to quantify variation in carpal bone shape and position as well as articulation morphology. Articular surface areas and interosseous proximity distributions were calculated between mesh vertex pairs on adjacent bones within distance (2.0 mm) and surface‐normal angular (35°) thresholds. In the SSM, the first five modes of variation captured 76.2% of shape variation and contributed to factors such as bone scale, articular geometries, and carpal tilt. Median interosseous proximities—a proxy for joint space—were 1.39 mm (scaphotrapezium), 1.42 mm (scaphotrapezoid), and 0.61 mm (trapeziotrapezoid). This study quantifies morphological and articular variations at the STT joint, presenting a range of normative anatomy. The range of estimated interosseous proximities may guide interpretation of imaging‐derived STT joint space.

Abstract Background Hemiarthroplasty may be indicated for patients with distal radioulnar joint (DRUJ) arthritis. Recently, the use of the pyrocarbon metacarpophalangeal implant has been proposed as a novel means of treating DRUJ arthritis due to the materials improved mechanical properties and wear characteristics. Purpose This study compares midterm outcomes of metallic and pyrocarbon hemiarthroplasties for the treatment of symptomatic DRUJ arthritis. Questions of interest included outcomes and complications. Materials and Methods In total, 32 hemiarthroplasties, 10 metallic and 22 pyrocarbon, were performed between 2010 and 2020 by three surgeons at one tertiary medical center. Patients' retrospective outcomes were extracted from the electronic medical record. Results Postoperatively, the metallic implant group (mean follow-up: 38 months) demonstrated decreased pain but no changes in range of motion. Comparatively, the pyrocarbon group experienced an improved range of motion and postoperative pain (p < 0.05). Radiographic analysis demonstrated 10% of metallic implants and 9% of pyrocarbon implants to have resulted in thinning of the lateral cortex of the radius at the final follow-up. Minor complications in metallic and pyrocarbon implant groups warranting reoperation occurred at rates of 10 and 13.5% while implant failure occurred at a rate of 30 and 18%, respectively. Discussion Within this study, pyrocarbon implants resulted in significant functional improvement with comparable complication and failure rates to the metallic implant. Long-term stability demonstrated efficacy for both techniques in symptomatic DRUJ treatment. Type of Study/Level of Evidence Observational Case Series IV.

Background: Metacarpophalangeal (MCP) joint arthritis is common secondary to a variety of inflammatory, degenerative, and traumatic causes. Although MCP arthroplasty is more common for the second to fifth digits, primary arthrodesis can be used for high-demand patients with arthritis or unsalvageable fractures of the MCP joint. There has been limited recent studies on the outcomes of these patients. Methods: A retrospective review of 38 fingers in 27 patients with primary arthrodesis from 1990 to 2020 was conducted. The major outcomes were complications, reoperations, radiographic union, and time to union. Patient-reported outcomes including the Michigan Hand Outcomes Questionnaire and a questionnaire specific to the operative MCP joint were collected. Results: Rate of radiographic union was 84% including revisions. The average time to union was 3.6 months. Rates of complications, reoperation, and amputation were 26%, 16%, and 7%, respectively. Arthrodesis as part of emergent trauma reconstruction was significantly more likely to result in reoperation (50% vs 7%) and complication (63% vs 17%) than chronic arthritis. Patient-reported outcomes were fair to good with improvement in pain (79%), function (66%), and appearance (40%). Sixty-six percent (66%) of patients were satisfied with their surgery, and 73% would repeat the surgery. Conclusion: Arthrodesis for unsalvageable MCP fractures was associated with higher rates of reoperation and complication than inflammatory or degenerative arthritis. Excluding emergent trauma, MCP fusion was reliable with a reoperation rate of 7% and a modest complication rate of 17%. Patients rated reasonable levels of satisfaction and willingness to repeat the procedure despite complications.