Amadio, Peter C.

Correspondence is presented recording an operation for release of the carpal tunnel performed in 1924, together with a biographical note on the surgeon, Herbert Galloway.

Flexor tendon repair remains one of the more difficult technical tasks facing the hand surgeon. A good repair must be both strong and able to glide smoothly through the tendon sheath. The purpose of this study is to present a model that allows surgeons to improve their technique of flexor tendon repair by receiving feedback on these important biomechanical parameters. The set-up requires testing equipment found in most biomechanical laboratories and should be available in many academic medical centres. Preliminary data suggest that receiving feedback about the strength and smoothness of a flexor tendon repair may be a very useful tool in helping surgeons improve the overall quality of their tendon repair technique.

We reviewed retrospectively a series of 128 consecutive patients who had wrist arthroscopy at our institution between January 1988 and July 1991. The aim of the procedure was to establish a diagnosis in 27 patients, to challenge a pre-operative diagnosis in 95 patients and to evaluate joint surfaces in six patients. For the 27 patients with a previously unknown diagnosis, the diagnostic sensitivity was 67% and the specificity 100%. Arthrotomy or other intervention was avoided in 18. For the 95 patients with an established pre-operative diagnosis, arthrotomy was avoided in 45: in 26 the desired procedure could be done arthroscopically, and in 19 the diagnosis, as improved by arthroscopy, was felt not to require further treatment. Procedures performed arthroscopically included débridement of triangular fibrocartilage and inter-carpal ligament tears; lysis of adhesions, and synovectomy. In six patients, arthroscopy was performed to evaluate joint surfaces after fracture reduction or before ulnar shortening osteotomy. In none of the six was arthrotomy felt necessary after arthroscopy. Wrist arthroscopy avoided the need for further surgery in 66 (52%) of our patients; arthrotomy was avoided in 69 (54%). In cases with significant carpal instability evident pre-operatively, arthroscopy was unlikely to avoid the need for open treatment.

12 adult cadaver wrists were dissected to identify the regions of origin of the four palmar radio-carpal ligaments. A non-dimensionalized value, called the radio-carpal ligament ratio (RLR), was defined as the width of ligament origin from the radius divided by the length of the capitate. Both values were measured directly from radiographs of the cadaver specimens. The RLRs for the four palmar radio-carpal ligaments were found to be statistically consistent. We applied the RLR concept retrospectively to 20 wrists with intraarticular distal radius fractures requiring open reduction. It was found that those fracture patterns in which the fracture fragment ratios (FFR: widths of the fracture fragments divided by the length of the capitate) were outside the limits of corresponding RLRs had clear intra-operative evidence of palmar radio-carpal ligament disruption, while those with FFRs within the limits of corresponding RLRs were noted to have no ligament disruption.

In order to determine the mechanical properties of the fibro-osseous pulleys in the hand, the diaphyseal annular pulleys, the volar plate annular pulleys and the cruciate or condensable portions were tested. A custom-made loading device provided proper fit of the soft tissues for a uniform distribution of the pulley load during testing. The A2 pulley was found to be the strongest of the pulleys; the A1 and A4 were the next strongest. The A3 pulley was nearly equal in mean breaking strength to the other annular pulleys, but in absolute breaking load was considerably weaker because of its shortness. The A4 was the least compliant of the pulleys. We concluded that the fibro-osseous A2 and A4 were mechanically stronger and stiffer pulleys than the A1, A3, A5 (volar plate) pulleys. In testing one type of pulley reconstruction, we found that the “belt loop” technique of Karev nearly matched the annular pulleys in strength and energy absorption.

An Italian version of the Disability of the Arm, Shoulder and Hand (DASH) questionnaire has been devised and its reliability and validity have been assessed in a cross-sectional study of 108 consecutive patients with upper extremity pathologies. A sub-sample of 30 patients was used to assess re-test reliability. The principal DASH scale showed a high correlation with other patient-oriented measures and demonstrated good reproducibility, consistency and validity, which were similar to those for other languages’ versions of DASH. These findings suggest that the evaluation capacities of the Italian DASH are equivalent to those of other language versions of the DASH.

The technique of surgical repair for zone two flexor tendon injuries has been debated extensively throughout the years, yet adhesion formation, suture rupture, and suture locking on the pulley edge remain possible consequences of a poor repair. The partially lacerated tendon is especially challenging to treat since there can be justification for not intervening surgically. In a partial laceration canine model we measured failure load and suture gap formation for tendons repaired with the Lee, modified four-strand Savage, Kessler, modified Kessler, and Augmented Becker core suture techniques and with a simple running peripheral suture. The modified Kessler (106.3 N, SD 18.8 N) and modified Savage (108.2 N, SD 19.9 N) repair techniques had a significantly higher failure load than the Lee (85.0 N, SD 20.6 N) suture method p<0.05, while there were no differences among the other techniques. There were no significant differences in resistance to gap formation among the repair techniques, with the mean values ranging from 38.9 N/mm (SD 15.7 N/mm) using the simple running suture to 53.2 N/mm (SD 25.8 N/mm) with the Kessler repair. The mean load to produce a 1.5 mm repair site gap ranged from 71.1 N (SD 21.5 N) in the Lee repair to 91.3 N (SD 22.2 N) in the Augmented Becker repair although there were no significant differences among repair methods. All repair methods were much weaker than tendons left unrepaired (184.7 N, SD 41.3 N). [S0148-0731(00)00706-8]